Iskald - "Shield" Zip-hoodie

Printed to order near you - DTG print on premium blanks - small variations may occur.

Some ISKALD products are printed to order close to you to avoid overproduction and unnecessary shipping. This is not mass stock.

We do not accept returns due to wrong size - please check the size chart carefully before ordering.

If you receive a defective print or shipping damage, email a photo to iskaldofficial@gmail.com within 14 days and we will send a replacement or issue a full refund.

Care: Wash inside out at 30°C / 86°F. Tumble dry low.

Do not iron directly on print.

A) Length

Place the end of a measuring tape beside the collar at the top of the hoodie (high point shoulder). Pull the tape to the bottom of the hoodie.

B) Half Chest

Lay the garment down on a flat surface and measure it from left to right across the chest, about 2cm below the arms.

C) Sleeve length

Place the end of a measuring tape at the center back of the collar, then pull the tape along the top seam of the sleeve. When you get to the shoulder hold the tape in place at the shoulder and continue to pull down the sleeve until you reach the hem of the sleeve.

Measurements are provided by suppliers and garments may run smaller or larger with a difference of +/- 2.5cm (1 in)

Metric (cm)

Imperial (inches)

	S	M	L	XL	2XL	3XL
A) Length	67.3 cm	69.9 cm	72.4 cm	74.9 cm	77.5 cm	80 cm
B) Width	104.2 cm	109.2 cm	114.4 cm	119.4 cm	124.4 cm	129.6 cm
B) Half Chest	52.1 cm	54.6 cm	57.2 cm	59.7 cm	62.2 cm	64.8 cm
C) Sleeve Length	63.5 cm	65.4 cm	67.3 cm	69.2 cm	71.1 cm	73 cm